CBT7 United Spa Control with heater (1)
3410030-1E Iron Might 115v pump (1)
400-4060 pump unions UN-P15 (2)
741-CGGG-45X pump power cord 4-wire (1)
411-4000 St Ell 90 1-1/2" SpgxS (1)
411-5550 Ell 90 1-1/2" SpgxSpg (1)
421-4070 Reducer Bushings 2" to 1.5" (2)
Baptistry Heater and pump by United Spa Controls, Heater System Complete with pump, heater, and control, 230 volt or 115 volt, 5000 watts or 1250 watts, ETL Listed for continuous use; 1-speed 1.6a 115v Energy Efficient pump, 5.0kw heater with time, and temperature control, programmable, convertible system, 115 volt OR 230 volts, with plumbing fittings.
A very reliable system, the United Spa Controls C5 Digital Control has been used for years in the baptistry and spa industry and has a great reputation for reliability. Quiet 1725 RPM Circulation pump.
The system is very flexible, can be set to a temperature and programmed using the digital display keypad. Overall height about 11".This is a very good basic 2-speed system to refurbish your baptistry, includes set of cords, owners manual, and topside display. And larger pumps are available at additional cost just email or call us with your old motor volts and amps rating.
If run on 230 volts, this would draw about 22.5 amps and belongs on a 4-wire circuit with a neutral, on 30a GFCI breaker. On 115v it would draw only 12.5 amps and belongs on a 20a GFCI breaker. Other larger pumps are available too (at additional cost). Topside keypad/display has a 9' cable and measures 2.5x5.0"
An all 230v system is available for 3-wire power, no neutral, just ask.
-Spa Control System with High Flow Heater
-Digital keypad/display 2.5x5"
-Cord set for topside, and pump.
-1 speed Pump
-Fittings for 1-1/2" pvc piping connection
-230 volts 4-wire 30 amps, OR, 115 volts 20 amps operation.
-heater specs 240/115v 5000 watts/1250 watts, high flow, 20GPM minimum
-pump specs 115v 1.6 amps
-plumbing size 1-1/2" pvc schedule 40.
-rough in dimensions 26L x 16W x 12"T
-topside keypad/display 2.50 x 5" (for flush mount, drops into a round 1-3/4" cutout)
-elevation, to be mounted below water level, for priming.
-weather resistance, this is rated for use out of the weather.
-from the factory, incoming power is set to 4-wire 230 volts with neutral. Tell us if you want that changed.